The cable must be configured as shown in Table 3-2.
TABLE 3-2 Pinout Assignment for the TI 700 Printer
MERLIN II Attendant
TI 700 Printer
Signal Ground—3
7/5—Signal Ground
Data Terminal
Ready-8
6/6-Data Set Ready
Data Set Ready-6
20/4—Data Terminal Ready
4/7—Request to Send
5/8-Clear to Send
Transmit Data—4
3/2—Receive Data
Receive Data-2
2/3—Transmit Data
Once the cable is configured and the printer is connected,
perform the following steps:
NOTE:
If any of the report counters exceed 65,535 total,
the counter is reset to 0.
Printing Call Handling
To
print a report, perform the following steps:
Reports
1
Dial the
MERLIN II Attendant extension from a
Touch-Tone phone, preferably a single-line set.
2 Wait for an answer.
3
Dial * followed immediately by the authorized
caller
code and #.
4 Dial *2909 and the following appropriate choice:
I=
print route programming
2=
print traffic analysis report
3=
print business schedule
4=
print announcement time allocations
5
Once the report is complete, exit authorized caller
mode by dialing *#.
6 To disconnect, dial #.
Troubleshooting 3-7
Commentaires sur ces manuels