AT&T 9110 Manuel d'utilisateur télécharger pdf (Page 8)

IN CASE OF DIFFICULTY

If you have difficulty operating

this phone, try the suggestions

below. If you still have trouble, call

1 800 722-9125.

If the phone does not work at all,

check these items first:

• Make sure the power cord is

plugged into an outlet not

controlled by a wall switch.

• Make sure the telephone line cord

is plugged firmly into the base and

the telephone jack.

• Make sure the base antenna is

upright.

• If the phone does not beep when

you press , the batteries

might need recharging.

• If the MUTE/LOW BATT

indicator is on, the batteries

need recharging.

• Make sure the battery pack is

installed correctly.

• If you have dial pulse service on

your telephone line, the Dial Mode

Switch must be set to PULSE.

If you hear noise or interference

when using the phone:

The advanced AutoSelect feature of

the phone should normally minimize

any interference. In some situations,

however, you might notice some

noise or interference when using the

phone. Follow the suggestions below.

• Make sure the base antenna is

upright.

• You may be out of range. Move

closer to the base.

• Household appliances plugged

into the same circuit as the base

can sometimes cause interference.

Try moving the appliance or the

base to another outlet.

• The layout of your home or office

may be limiting the operating

range. Try moving the base to

another location—preferably on an

upper floor.

If the phone does not ring when

you receive a call:

• Make sure the ringer is turned on.

If you are away from the base,

make sure the base antenna is

upright.

• Make sure the telephone line cord

is connected firmly to the base and

the telephone jack. Make sure the

power cord is plugged in.

• You may be too far from the base.

Move closer to the base.

• You may have too many extension

phones on your telephone line to

allow all of them to ring. Try

unplugging some of the other

phones.

If you hear other calls while using

the phone:

• Disconnect the base from the tele-

phone jack, and plug in a regular

telephone. If you still hear other

calls, the problem is probably in

your wiring or local service. Call

your local phone company.

If you hear noise in the handset,

and the buttons don’t work:

• Make sure the power cord is

plugged in, and make sure the

base antenna is upright.

If you are unable to operate special

telephone services or other equip-

ment requiring touch tone signals:

• If you have dial pulse (rotary) ser-

vice, press on the handset

before entering information (see

“Temporary Tone”).

• The tones generated by this

phone may not be long enough

to activate some services or

equipment. You might need to

use a different touch tone phone.

If you have difficulty entering

numbers into Memory:

• Review “Programming a Number

into Memory” to make sure you

are pressing the correct sequence

of buttons.

• If the number is more than 20

digits long, make sure you follow

the instructions for “Programming

a Number into Memory.”

Make sure you have followed all

the instructions in this booklet.

If you continue to have problems,

call 1 800 722-9125.

8

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire