AT&T OneVision DEFINITY G3 Guide Guide de l'utilisateur télécharger pdf (Page 141)

DEFINITY Performance Management User Guide, Release 2.0, 585-229-808

7 Administer Reports

Select Managed Nodes

Issue 1

November 1998

Page 141

Result:

If the managed node you checked has individual components, a list of

those components displays in the right side of the pane. See the

table following this procedure for a list of report types and

corresponding components.

4 For each system selected, are there any components listed in the right side of

the pane?

• If yes, go to the next step.

• If no, go to step 7.

5 If the managed node has associated individual components for the report type

selected, such as tone receiver types, select which components to report on:

• To select individual components, put a checkmark next to the desired

component in the selection list. The default is all components.

• If you are reporting on a trunk group, go to the next step.

• To select all components, click

Select All.

• To clear all components so that none are selected, click

Clear All.

For additional details about components, see the table

"Report Type and

Component List" on page 142

for a list of report types and corresponding

components.

6 If you are reporting on trunk groups and if there are any trunk group lists

defined for that managed node, you can select an individual, multiple, or any

combination of trunk group lists by clicking on the

Show trunk group lists

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 222 223

Pas de commentaire

AT&T OneVision DEFINITY G3 Guide Guide de l'utilisateur Page 141