AT&T Synapse SB67070 SIP Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Passerelles/contrôleurs AT&T Synapse SB67070 SIP. AT&T Synapse SB67070 SIP Installation guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 15
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
© 2012 Advanced American Telephones. All Rights Reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property licensed to Advanced
American Telephones, San Antonio, TX 78219. Synapse® is a registered trademark of Advanced American Telephones. Rev. 1 01/12
Configuring the Synapse® SB67070 SIP Gateway
for Broadvox GO! SIP Trunking
Application Note
Vue de la page 0
1 2 3 4 5 6 ... 14 15

Résumé du contenu

Page 1 - Application Note

© 2012 Advanced American Telephones. All Rights Reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property licensed to

Page 2 - Table of Contents

Application Note 9

Page 3 - Gateway

Application Note Configuring the SIP Gateway To configure SIP Account Settings: 1. In the navigation menu at left, click SIP Gateway Settings. The SI

Page 4 - Purpose, Scope, and Audience

Application Note b. Enter the Account Name. The SIP account name appears on the Dial Plan Settings page and the Trunk Reservation page. c. For Max C

Page 5 - Synapse External IP Address

Application Note The SIP Gateway uses the audio codecs in the order they are listed on a per call basis. You can choose codecs based on the speed vers

Page 6

Application Note Configuring the Dial Plan Before configuring the Dial Plan, see “Dial Plan Settings” in the Synapse System Administrator’s Guide (for

Page 7 - SRV Records

Application Note 14 3. Set the Call Log/Messages Prefix according to your Dialing Rules. You can enter a maximum of eight digits using only the chara

Page 8

Table of Contents About Synapse® and the Synapse SB67070 SIP Gateway... 2 Purpose, Scope, and Audience ...

Page 9

Application Note About Synapse® and the Synapse SB67070 SIP Gateway Synapse is an IP-based PBX system that integrates seamlessly into an existing Loca

Page 10

Application Note Purpose, Scope, and Audience This technical application note describes the configuration of the SB67070 SIP Gateway for the Broadvox

Page 11 - Configuring the SIP Gateway

Application Note SIP Gateway IP Address: ______.______.______.______ (on the SIP Gateway LCD) Max Calls: __________ Preferred Codec: ulaw G.711 Altern

Page 12

Application Note Figure3:FirewallConfigurationInformationThe third page also contains the IP address and DNS information you should use for conf

Page 13

Application Note receive calls from your system. These two sections are only utilized if you provided static IP address information or DNS information

Page 14 - Configuring the Dial Plan

Application Note device to allow the SIP Gateway to function properly. Additionally, you may be using an Application Gateway such as an Ingate SIParat

Page 15

Application Note Installing the SB67070 SIP Gateway To install the SIP Gateway, see the Synapse Installation Guide (for software 1.10.4 or later) avai

Commentaires sur ces manuels

Pas de commentaire